Course List

Customer List

Learning Resources

TSTC - Texas State Technical College

A&M University TEEX, Electrical Power Division

Fundamentals of HVAC systems: Gas compression cycle.
Air & Water Systems Balancing: HVAC & R, Air-water distribution systems, NEBB certification testing preparation.

Electrical

Basic Electrical: Source, path, loads, controls, safety, circuits, volts, current, and resistance, etc.

Cogeneration Plant Operation & Maintenance: Combined cycle, bolters, turbines, and generators.

Electrical Circuit Breakers: Low and medium voltage, MCCB, ICCB, MCP, RCD, AFCI, GFCI, Thermal magnetic, bolt in, stablock and drawout types.
Electrical Motor Controls: Two-three wire circuits, timers, starters and pilot devices.
Electrical Power Distribution Systems: Plant power supplies.
Electrical Safety: Standard for Electrical Safety in the Workplace, NFPA 70E.

Electrical Systems Troubleshooting: Motors, controls, and circuits.

Ground Fault Circuit Interrupters GFCI, Arch Fault Circuit Interrupters AFCI, and Residual Current Devices (RCDs): Introduction, Test & Operation, short circuits and ground faults.

Ladder Diagrams Electrical: Relay logic, loads, controls, and troubleshooting.
LOTO: OSHA, stored energy. Company policies and procedures.
Meters: Electrical, Volt, Ohm, Meger, and Ground resistance.
Motors: Electrical 3 phase, stator, rotor, and housing, etc.
Motor Starters: Full and reduced voltage, Wye-Delta, auto-transformer, and solid state.

National Electrical Code: Introduction, journeyman's test preparation.
NFPA-70 NEC, 70-B Maintenance, 70-E Electrical Safety, and 101 Life safety.

PLC: Generic, Allen Bradley. Basic, for non-programmers

Stand by and Emergency Power Generators: Prime movers, generators, controls, load banks, etc.
Transformers: Electrical, dry and oil cooled, 1 and 3 phase.

UPS: Motor-generator sets, battery backup, and on line types.

Variable Frequency Drives: AC, generic and Allen Bradley, etc.

Instrumentation and Controls

Fundamentals of Instrumentation and Controls: Open & closed loop, pressure, level, temperature, and flow etc.

Oil & Gas Production Operations

Off Shore O & G Platform Electric Power Production
Screw Compressors, oil free: Operation, maintenance, lubrication, seals and fire suppression systems, etc.